Kathrein MSK 25 manual Nicam Sound Bit Error Rate Measurement, Example SC 5.85 MHz BER=2.145E-05

Page 39

TV measurement

Note

☞

Press [3] while the sound carrier is displayed

The sound carrier frequency is not adjustable but changed over according to the standard which has been set.

The sound carrier level is only displayed when key [2] or [3] is pressed.

NICAM Sound Bit Error Rate Measurement

The bit error rate may be measured for an improved evaluation of the

Nicam signal sound quality.

Example

✐

 

 

SC: 5.85 MHz

TV

BER=2.145E-05

 

 

 

 

 

Calling up bit error measurement:

Press [2ndF] [SC]

Press [3]

In case there are no bit errors identified due to a strong signal, BER=0.000 is indicated on the display.

In case there is hardly a signal or no signal at all received, OVERFLOW is indicated on the display.

39

Page 38 Page 40
Image 39
Page 38 Page 40
Contents MSK 25 Satellite/TV/FM Test Receiver analogue/digital Preface Contents Mpeg Picture Representation option in DVB-C or DVB-T option Additionally included in Delivery Signs and SymbolsSafety Rules General InformationPage Cofdm Overview of FunctionsQpsk QAMLNB 0/5 20 SAT Technical DataDVB-S-MER1 TFT Colour Screen Control Elements and IndicatorsControl Elements Connections right hand sideSAT/DVB-S TV/DVB-C/*DVB-T Short Cut OverviewScart Output ConnectionsRF Input Socket External DC Voltage SupplySoftware Accu −−−−− LEV 48.5dBuV Switching-UpSwitching-Off CommissioningSetup Menu Call-Up Setup-MenuFactory Setting on Delivery Setup Menu SettingMains Operation and Battery Operation Battery OperationMains Operation Press 2ndF STD SAT measurementStandard Change-Over 2ndF STDLEV 86.5dBuV Frequency Display and Frequency EntrySAT Menu Frequency Entry Example FR1508.0MHzSAT Analogue Level Measurement SAT DVB-S Level MeasurementLevel Overflow and Level Underflow 2ndF 2ndF Exit Calling up Scan mode Press 2ndF ScanLocating Satellites Scan Menu LEV-Range2 SAT ExampleBearing for Individual Reception Frequencies Bearing Menu LEV-Range2 SAT ExamplePress 2ndF Level SAT Analogue Sound Carrier Frequency Press 2ndF SCBwnarrow MER12.6dB MHz BER1.7e-7 DVB-S MER, BER and Offset MeasurementMpeg Picture Representation option in DVB-S Calling up DVB-S measurementPress 2ndF LNB LNB Voltage and 22 kHz/60 Hz Change-OverPress 2nF LNB Example LNB14,0V 22kHz 150mAOr + DiSEqC Digital Satellite Equipment ControlFraming Byte Menu Press 2ndF SAT-CTRLHEX Hex Byte Description Address Byte MenuCommand Byte Menu SAT measurement 2ndF 2ndF Simple Tone Burst DiSEqCData Byte Menu 2ndF SAT-CTRLTV measurement Bis=ANALOG 3=DVBT DVB-C/DVB-T Change-Over Press ./S 1 TV Channel Setting Menu Example CHS.11 LEV 62,5dBuVChannel display and channel entry Changing over to special channelThen press 1 7 5 ./S 2 5 Enter TV Frequency Entry Mode Example CH175,25 LEV 65,0dBuVLEV.dBuV Level Measurement TV AnalogueTV/DVB-C/DVB-T Level Measurement LEV.dBuVLEV-RANGE2 TV Bearing MenuSound Carrier Distance and Sound Carrier Level TT1 TT22ndF SC Example SC 5.85 MHz BER=2.145E-05 Nicam Sound Bit Error Rate MeasurementCalling up DVB-C/DVB-T option measurement DVB-C/DVB-T option, MER, BER and Offset MeasurementMpeg Picture Representation option in DVB-C or DVB-T option MER30.5dB MHz BER2.0e-8Then press 9 9 ./S 2 5 Enter FM measurementFrequency Indication and Frequency Entry FM Frequency Entry Menu Example LEV 65.0dBuVLevel Measurement Fr104.80MHz LEV 86.5dBuVFR104.80MHz LEV .dBuV FR104,80MHz LEV¯¯¯.¯dBuV LEV-RANGE2 FM SAT-Full Spectrum MeasurementSAT Spectrum TV SpectrumTV-Narrow FM SpectrumTV Spectrum Menu TV-Full VHF UHFMaintenance Changing the BatteryCustomer Service Signal-to-Noise-Ratio Technical Appendix+14.1 dB Instruction Set for EXR 22 Kathrein Matrix DiSEqC Commands for Kathrein MatricesInstruction Set for 9xx Kathrein Matrix Production Run Instruction Set for EXR 20 Kathrein MatrixVRF-CCIR URF-CCIR Channel TablesVHF UHF III Technical Appendix Technical Appendix Technical Appendix Technical Appendix 936.2642/D/1005/ZWT Subject to technical modifications
Top Page Image Contents