Kathrein MSK 25 manual Locating Satellites, Scan Menu LEV-Range2 SAT Example, 2ndF 2ndF Exit

SAT measurement

Locating Satellites

SCAN Menu

À

LEV-Range:2 SAT

>■■■■

Example

✐

With the SCAN function, satellites, the exact transponder frequencies of which are unknown, can be located. In doing so, the frequency range from 1000 MHz to 2100 MHz is continuously scanned for received signals. If signals are received, the reception level is displayed as a bar graph. The measurement range may be adjusted to three different sensitivity levels.

The level can be monitored with an acoustic signal, the pitch of which is proportional to the received-signal level. The volume of the acoustic signal can be adjusted with the volume regulator.

[2ndF] [SCAN] Changing over to SCAN mode

[-] [+]	Change-over of the bar graph measurement range.
	Level range 1: high input levels
	Levelrange 2: medium input levels
	Level range 3: low input levels

[2ndF] [2ndF] Exit

LC display:

•Level range 2: medium input level

•SAT mode

•Bargraph display

Calling up SCAN mode:

•Press [2ndF] [SCAN].

•Move the antenna until there is a level tendency visible on the bargraph display.

•Move the antenna until the maximum amplitude on the bargraph display is reached.

•If necessary, diminish or elevate the sensitivity by pressing either [-]or

[+].

Exit:

•Press [2ndF] twice.

20