Kathrein MSK 25 manual Level Measurement, Fr104.80MHz LEV 86.5dBuV

Page 42

FM measurement

Level Measurement

 

 

Fr:104.80MHz

FM

LEV: 86.5dBuV

A │

 

 

 

 

After you have set a frequency, the level is automatically measured and displayed in dBµV. The input level can be measured in the range of 30 dBµV to 120 dBµV.

LC display:

Frequency: 104.8 MHz

Mode: FM

Level measured: 86.5 dBµV

Level Overflow and Level Underflow

The LC display indicates underflow at a level of < 30 dBµV.

 

 

FR:104.80MHz

FM

LEV: ___._dBuV

A │

 

 

 

 

 

 

FR:104,80MHz

FM

LEV:¯¯¯.¯dBuV

A │

 

 

 

 

LC display:

Frequency: 104.8 MHz

Mode: FM

Level: underflow

The LC display indicates overflow at a level of > 120 dBµV.

LC display:

Frequency: 104.8 MHz

Mode: TV

Level: overflow

42

Image 42
Contents MSK 25 Satellite/TV/FM Test Receiver analogue/digital Preface Contents Mpeg Picture Representation option in DVB-C or DVB-T option General Information Signs and SymbolsSafety Rules Additionally included in DeliveryPage QAM Overview of FunctionsQpsk CofdmLNB 0/5 20 Technical Data SATDVB-S-MER1 Connections right hand side Control Elements and IndicatorsControl Elements TFT Colour ScreenShort Cut Overview SAT/DVB-S TV/DVB-C/*DVB-TExternal DC Voltage Supply ConnectionsRF Input Socket Scart OutputCommissioning Switching-UpSwitching-Off Software Accu −−−−− LEV 48.5dBuVSetup Menu Setting Setup-MenuFactory Setting on Delivery Setup Menu Call-UpMains Operation and Battery Operation Battery OperationMains Operation 2ndF STD SAT measurementStandard Change-Over Press 2ndF STDExample FR1508.0MHz Frequency Display and Frequency EntrySAT Menu Frequency Entry LEV 86.5dBuVSAT Analogue Level Measurement SAT DVB-S Level MeasurementLevel Overflow and Level Underflow Scan Menu LEV-Range2 SAT Example Calling up Scan mode Press 2ndF ScanLocating Satellites 2ndF 2ndF ExitBearing for Individual Reception Frequencies Bearing Menu LEV-Range2 SAT ExamplePress 2ndF Level SAT Analogue Sound Carrier Frequency Press 2ndF SCBwnarrow Calling up DVB-S measurement DVB-S MER, BER and Offset MeasurementMpeg Picture Representation option in DVB-S MER12.6dB MHz BER1.7e-7LNB Voltage and 22 kHz/60 Hz Change-Over Press 2ndF LNBExample LNB14,0V 22kHz 150mA Press 2nF LNBDiSEqC Digital Satellite Equipment Control Or +Framing Byte Menu Press 2ndF SAT-CTRLHEX Address Byte Menu Hex Byte DescriptionCommand Byte Menu SAT measurement 2ndF SAT-CTRL Simple Tone Burst DiSEqCData Byte Menu 2ndF 2ndFTV measurement Bis=ANALOG 3=DVBT DVB-C/DVB-T Change-Over Changing over to special channel TV Channel Setting Menu Example CHS.11 LEV 62,5dBuVChannel display and channel entry Press ./S 1TV Frequency Entry Mode Example CH175,25 LEV 65,0dBuV Then press 1 7 5 ./S 2 5 EnterLEV.dBuV Level Measurement TV AnalogueTV/DVB-C/DVB-T Level Measurement LEV.dBuVBearing Menu LEV-RANGE2 TVSound Carrier Distance and Sound Carrier Level TT1 TT22ndF SC Nicam Sound Bit Error Rate Measurement Example SC 5.85 MHz BER=2.145E-05MER30.5dB MHz BER2.0e-8 DVB-C/DVB-T option, MER, BER and Offset MeasurementMpeg Picture Representation option in DVB-C or DVB-T option Calling up DVB-C/DVB-T option measurementFM Frequency Entry Menu Example LEV 65.0dBuV FM measurementFrequency Indication and Frequency Entry Then press 9 9 ./S 2 5 EnterLevel Measurement Fr104.80MHz LEV 86.5dBuVFR104.80MHz LEV .dBuV FR104,80MHz LEV¯¯¯.¯dBuV LEV-RANGE2 FM TV Spectrum Spectrum MeasurementSAT Spectrum SAT-FullVHF UHF FM SpectrumTV Spectrum Menu TV-Full TV-NarrowMaintenance Changing the BatteryCustomer Service Signal-to-Noise-Ratio Technical Appendix+14.1 dB Instruction Set for EXR 20 Kathrein Matrix DiSEqC Commands for Kathrein MatricesInstruction Set for 9xx Kathrein Matrix Production Run Instruction Set for EXR 22 Kathrein MatrixChannel Tables VRF-CCIR URF-CCIRVHF UHF III Technical Appendix Technical Appendix Technical Appendix Technical Appendix 936.2642/D/1005/ZWT Subject to technical modifications