Nortel Networks 2500 Series manual Sntp server secondary address command, No sntp server command

210System configuration using the CLI

Table 69 "sntp server primary address command parameters and variables" (page 210) describes the parameters and variables for the sntp server primary address command.

Table 69

sntp server primary address command parameters and variables

Parameters and	Description
variables
<A.B.C.D>	Enter the IP address of the primary NTP server.

The default is 0.0.0.0.

sntp server secondary address command

The sntp server secondary address command specifies the IP addresses of the secondary NTP server. The syntax for the sntp server secondary address command is:

sntp server secondary address <A.B.C.D>

The sntp server secondary address command is executed in the Global Configuration command mode.

Table 70 "sntp server secondary address command parameters and variables" (page 210) describes the parameters and variables for the sntp server secondary address command.

Table 70

sntp server secondary address command parameters and variables

Parameters and	Description
variables
<A.B.C.D>	Enter the IP address of the secondary NTP server.

The default is 0.0.0.0.

no sntp server command

The no sntp server command clears the NTP server IP addresses. The syntax for the no sntp server command is:

no sntp server <primarysecondary>

The no sntp server command is executed in the Global Configuration command mode.

Table 71 "no sntp server command parameters and variables" (page

211)describes the parameters and variables for the no sntp server command.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks