Setting time on network elements using Simple Network Time Protocol 209

Figure 73

show sntp command output

sntp enable command

ATTENTION

The default setting for SNTP is disabled.

The sntp enable command enables SNTP. The syntax for the sntp enable command is:

sntp enable

The sntp enable command is executed in the Global Configuration command mode.

The sntp enable command has no parameters or variables.

no sntp enable command

The no sntp enable command disables SNTP. The syntax for the no sntp enable command is:

no sntp enable

The no sntp enable command is executed in the Global Configuration command mode.

The no sntp enable command has no parameters or variables.

sntp server primary address command

The sntp server primary address command specifies the IP addresses of the primary NTP server. The syntax for the sntp server primary address command is:

sntp server primary address <A.B.C.D>

The sntp server primary address command is executed in the Global Configuration command mode.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks

Page 209
Image 209
Nortel Networks 2500 Series manual Sntp enable command, No sntp enable command, Sntp server primary address command