92CLI Basics

The interface command is executed in the Global Configuration command mode.

Table 12 "interface command parameters and variables" (page 92) describes the parameters and variables for the interface command.

Table 12

interface command parameters and variables

Parameters

Description

and variables

 

<portlist>

Specifies the portlist you want to be affected by all the

 

commands issued in the config-if command mode.

disable command

The disable command returns you to the User EXEC (exec) command mode. The syntax for the disable command is:

disable

The disable command is executed in the Privileged EXEC command mode.

The disable command has no parameters or variables.

end command

The end command moves you to the priv Exec mode from either the Global Configuration (config) mode or the Interface Configuration (config-if) mode.

The syntax for the end command is:

end

The end command has no parameters or variables.

exit command

The exit command moves you around the command modes:

In User EXEC (exec) and Privileged EXEC (privExec) command modes, exit lets you quit the CLI session.

In Global Configuration (config) mode, exit moves you back to the privExec command mode.

In Interface Configuration (config-if) command mode, exit moves you back to the Global Configuration command mode.

The syntax for the exit command is:

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks

Page 92
Image 92
Nortel Networks 2500 Series manual Disable command, End command, Exit command, Syntax for the end command is