Nortel Networks 2500 Series Displaying topology information using Device Manager, Topology tab

Displaying topology information using Device Manager 279

3Type the number of minutes to shift the clock in the Offset box.

4Select the StartYear, StartMonth, StartDate, StartHour, and type the StartMinutes to define when to switch the clock to daylight saving time.

5Select the EndYear, EndMonth, EndDate, EndHour, and type the EndMinutes (if applicable) to define when to switch the clock back to normal time. If you want to keep the same daylight saving time changeover dates, you can set the EndYear to a year in the future.

6Click Enabled to enable daylight savings time.

7Click Apply.

—End—

Displaying topology information using Device Manager

This section describes diagnostic information available in Device Manager on the following tabs:

•"Topology tab" (page 279)

•"Topology Table tab" (page 280)

Topology tab

To view topology information, use the following procedure:

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks