Nortel Networks 2500 Series manual Poe poe-power-usage-threshold command, Legacy

Configuring PoE switch parameters using the CLI 159

poe poe-pd-detect-type

{802dot3af 802dot3af_and_legacy Unit}

The poe poe-pd-detect-typecommand is executed in the Global Configuration command mode.

ATTENTION

You must ensure that this setting is the correct one for the IP appliance you use with the switch. Please note this setting applies to the entire switch, not port-by-port. So, you must ensure that this setting is configured correctly for all the IP appliances on a specified switch.

describes the parameters and variables for the poe poe-pd-detect-type command.

Table 34

poe poe-pd-detect-type command parameters and variables

Parameters and	Description
variables
802dot3af	Sets the detection method the switch use to detect power needs of devices
802dot3af_and
	connected to front ports:
_legacy
	• 802dot3af
	• 802dot3af_and_legacy

	ATTENTION
	The default setting is 802dot3af. Ensure that the power detection method
	you choose for the Ethernet Routing Switch 2500-PWR matches that used
	by the IP devices you are powering.
Unit	Set the unit in stack to apply the detection method.

poe poe-power-usage-threshold command

The poe poe-power-usage-threshold command lets you set a percentage usage threshold above which the system sends a trap for each Ethernet Routing Switch 2500-PWR. The syntax for the poe poe-power-usage-threshold command is:

poe poe-power-usage-threshold {<1-99> Unit}

The poe poe-power-usage-threshold command is executed in the Global Configuration command mode.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks