Nortel Networks 2500 Series manual Default lldp command, Lldp config-notification command

Configuring LLDP using the CLI 219

default lldp command

The default lldp command sets the LLDP transmission parameters to their default values. The syntax for the default lldp command is:

default lldp [tx-interval] [tx-hold-multiplier] [reinit-delay] [tx-delay] [notification-interval]

If no parameters are specified, the default lldp command sets all parameters to their default values.

The default lldp command is executed in the Global Configuration command mode.

Table 77 "default lldp command parameters and variables" (page

219)describes the parameters and variables for the default lldp command.

Table 77

default lldp command parameters and variables

Parameters and	Description
variables
tx-interval	Sets retransmit interval to the default value (30).
tx-hold-multiplier	Sets transmission multiplier to the default value (4).
reinit-delay	Sets reinitialize delay to the default value (2).
tx-delay	Sets transmission delay to the default value (2).
notification-interva	Sets notification interval to the default value (5).
l

lldp config-notification command

The lldp config-notificationcommand enables notification when new neighbor information is stored or when existing information is removed.

The syntax for the lldp config-notificationcommand is:

lldp [port <portlist>] config-notification

The lldp config-notificationcommand is executed in the Interface Configuration command mode.

Table 78 "lldp config-notification command parameters and variables" (page

220)describes the parameters and variables for the lldp config-notification command.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks