Naming ports 235

Table 92

no shutdown command parameters and variables

Parameters and

Description

variables

 

line <portlist>

Specifies the port numbers to enable. Enter the port

 

 

numbers you want to disable.

ATTENTION

If you omit this parameter, the system uses the port number you specified in the interface command.

Naming ports

You can name a port using the CLI. This section covers the following commands:

"name command" (page 235)

"no name command" (page 236)

"default name command" (page 236)

name command

The name command lets you name ports or to change the name. The syntax for the name command is:

name [port <portlist>] <LINE>

The name command is executed in the Interface Configuration command mode.

Table 93 "name command parameters and variables" (page 235) describes the parameters and variables for the name command.

Table 93

name command parameters and variables

Parameters and

Description

variables

 

port <portlist>

Specifies the port numbers to name.

 

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks

Page 235
Image 235
Nortel Networks 2500 Series manual Naming ports, Name command No name command Default name command