Nortel Networks 2500 Series manual Configuring Lldp using the CLI, Show autotopology nmm-table

Configuring LLDP using the CLI 217

Figure 76 "show autotopology settings command output" (page 217) displays a sample output of the show autotopology settings command.

Figure 76

show autotopology settings command output

show autotopology nmm-table

The show autotopology nmm-table command displays information about the network management module (NMM) table. The syntax for the show autotopology nmm-table command is:

show autotopology nmm-table

The show autotopology nmm-table command is executed in the Privileged EXEC command mode.

The show autotopology nmm-table command has no parameters or variables.

Figure 77 "show autotopology nmm-table command output" (page

217)displays a sample output of the show autotopology nmm-table command.

Figure 77

show autotopology nmm-table command output

Configuring LLDP using the CLI

You can enable the LLDP using the CLI. For more information about LLDP, see "Link Layer Discovery Protocol (IEEE 802.1ab)" (page 74). This section covers the following commands:

•"lldp command" (page 218)

•"default lldp command" (page 219)

•"lldp config-notification command" (page 219)

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks