Nortel Networks 2500 Series manual Configure network command, Show config-network command

Configuration Management 189

•"show config-network command" (page 190)

configure network command

The configure network command lets you load and execute a script immediately and to configure parameters to automatically download

a configuration file when you reboot the switch. The syntax for the configure network command is:

configure network [load-on-boot {disableuse-bootpuse-config}] [filename <WORD>] [address <XXX.XXX.XXX.XXX>]

The configure network command is executed in the User Exec mode.

ATTENTION

When you enter configure network with no parameters, the system prompts you for the script file name and TFTP server address and then downloads the script.

Table 56 "configure network command parameters and variables" (page

189)describes the parameters and variables for the configure network command.

Table 56

configure network command parameters and variables

Parameters and	Description
variables
load-on-boot {disableuse-b	Specifies the settings for automatically loading a configuration file
ootpuse-config
	when the system boots:
	• disable—disables the automatic loading of config file
	• use-boot—specifies using the BootP file as the automatically
	loaded config file
	• use-config—specifies using the ASCII configuration file as the
	automatically loaded config file

ATTENTION

When you enter configure network with no parameters, the system prompts you for the script file name and TFTP server address and then downloads the script.

If you omit this parameter, the system immediately downloads and runs the ASCII config file.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks