Nortel Networks 2500 Series manual Default lldp tx-tlv command, Lldp status command

222System configuration using the CLI

Parameters and	Description
variables
port-desc	Port description TLV.
sys-cap	System capabilities TLV
sys-desc	System description TLV
sys-name	System name TLV

default lldp tx-tlv command

The default lldp tx-tlvcommand specifies the optional TLVs not to include in the transmitted LLDPDUs (by default, the optional TLVs are not included in LLDPDUs). The syntax for the default lldp tx-tlvcommand is:

default lldp tx-tlv [port <portlist>] [local-mgmt-addr] [port-desc]

[sys-cap] [sys-desc] [sys-name]

The default lldp tx-tlvcommand is executed in the Interface

Configuration command mode.

Table 83 "default lldp tx-tlv command parameters and variables" (page

222)describes the parameters and variables for the default lldp tx-tlv command.

Table 83

default lldp tx-tlv command parameters and variables

Parameters and	Description
variables
port <portlist>	Specifies the ports affected by the command.
local-mgmt-addr	Local management address TLV (default value is false: not
	included)
port-desc	Port description TLV. (default value is false: not included)
sys-cap	System capabilities TLV (default value is false: not included)
sys-desc	System description TLV (default value is false: not included)
sys-name	System name TLV (default value is false: not included)

lldp status command

The lldp status command sets the LLDPU transmit and receive status on ports. The syntax for the lldp status command is:

lldp [port <portlist>] status [rxOnly txAndRx txOnly]

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks