Nortel Networks 2500 Series manual PoE tab items page 176 describes the PoE tab items

176Power over Ethernet for the Ethernet Routing Switch 2526T-PWR and 2550T-PWR

—End—

PoE tab items

Table 46 "PoE tab items" (page 176) describes the PoE tab items.

Table 46

PoE tab items

Item	Description
AdminEnable	Lets you enable or disable PoE on this port.
	By default, PoE is enabled.
Detection Status	Displays the operational status of the power-device
	detecting mode on the specified port:
	• disabled—detecting function disabled
	• searching—detecting function is enabled and the
	system is searching for a valid powered device on
	this port
	• deliveringPower—detection found a valid powered
	device and the port is delivering power
	• fault—power-specific fault detected on port
	• test—detecting device in test mode
	• otherFault

		ATTENTION
		Nortel recommends against using the test
		operational status.
PowerClassifications	Classification is a way to tag different terminals on
	the Power over LAN network according to their power
	consumption. Devices such as IP telephones, WLAN
	access points, and others can be classified according to
	their power requirements.
PowerPriority	Lets you set the power priority for the specified port to:
	•	critical
	•	high
	•	low

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks