Nortel Networks 2500 Series manual Download command, Syntax for the download command is

230System configuration using the CLI

CAUTION

Do not interrupt power to the device during the software download process. A power interruption can corrupt the firmware image.

This section contains information about the following:

•"download command" (page 230)

download command

The download command upgrades the software for the Ethernet Routing Switch 2500 Series. You can upgrade both the software image and the diagnostics image.

ATTENTION

The system resets after downloading a new image.

The syntax for the download command is:

download [address <ip>] {image <image-name>image-if-newer <image-name>diag <filename> [no-reset] poe-module-image }

The download command is executed in the Privileged EXEC command mode.

ATTENTION

You can use the download command without parameters. The system displays the most recently used TFTP server IP address and file name; if you still want to use these, press Enter. You can also change these.

Table 90 "download command parameters and variables" (page

230)describes the parameters and variables for the download command.

Table 90

download command parameters and variables

Parameters and	Description
variables
address <ip>	Specifies the IP address of the TFTP server you want to
	use.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks