Nortel Networks 2500 Series manual Poe poe-limit command parameters and variables

Configuring PoE port parameters using the CLI 163

Parameters and	Description
variables

ATTENTION

If you omit this parameter, the system uses the port entered with the interface FastEthernet command.

low high	Sets the port priority as:
critical

•

low

•

high

•

critical

ATTENTION

The default setting is low. When two ports have the same priority and one must be shut down, the port with the higher port number is shut down first.

poe poe-limit command

The poe poe-limitcommand sets the maximum power allowed to a port. The syntax for the poe poe-limitcommand is:

poe poe-limit [port <portlist>] <3-16>

The poe poe-limitcommand is executed in the Interface Configuration command mode.

Table 39 "poe poe-limit command parameters and variables" (page

164)describes the parameters and variables for the poe poe-limit command.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks