Nortel Networks 2500 Series manual Show config-network command

190System configuration using the CLI

Parameters and	Description
variables
filename <WORD>	Specifies the file name.

ATTENTION

If you omit this parameter and do not specify BootP, the system uses the configured file name.

address <XXX.XXX.XXX.X XX>

Specifies the TFTP server from which to load the file. Enter the IP address in dotted-decimal notation.

ATTENTION

If you omit this parameter and do not specify BootP, the system uses the configured address.

ATTENTION

When you specify the file name or address, these parameters change at the next reboot, even if you do not specify load-on-boot.

show config-network command

The show config-networkcommand displays information regarding the automatic loading of the configuration file, including the current status of this feature, the file name, the TFTP server address, and the status of the previous automatic configuration command. The syntax for the show config-networkcommand is:

show config-network

The show config-networkcommand is executed in the Privileged EXEC command mode.

The show config-networkcommand has no parameters or values.

Figure 61 "show config-network command output" (page 191) shows the output for the show config-network command.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks