320Configuring the switch using web-based management

Figure 118

IP page

The following table describes the items on the IP page.

Table 142

IP page items

Section

Item

Range

Description

 

 

 

 

Boot Mode

BootP

BootP or Default IP (default)

Choose this mode to inform the

Setting

Request

 

switch to send a BootP request

 

Mode

 

when the switch IP address

 

 

 

stored in nonvolatile memory is

 

 

 

the factory default value. If the

 

 

 

stored IP address differs from

 

 

 

the factory default value, the

 

 

 

switch uses the stored network

 

 

 

parameters. If the switch cannot

 

 

 

find a BootP server, it tries five

 

 

 

more times to find one and then

 

 

 

defaults to the factory settings

 

 

 

 

 

 

BootP Always

Choose this mode to inform

 

 

 

the switch to ignore any stored

 

 

 

network parameters and send

 

 

 

a BootP request, each time it

 

 

 

boots. If the BootP request

 

 

 

fails, the switch boots with the

 

 

 

factory default IP configuration.

 

 

 

This setting disables remote

 

 

 

management if no BootP server

 

 

 

is set up for the switch, but lets

 

 

 

the switch boot normally.

 

 

 

 

 

 

BootP Disabled

Choose this mode to inform the

 

 

 

switch to use the IP configuration

 

 

 

parameters stored in nonvolatile

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks

Page 320
Image 320
Nortel Networks 2500 Series manual Following table describes the items on the IP, IP page items Section Range Description