Nortel Networks 2500 Series manual Setting port speed, Speed command

Setting port speed 237

Table 95

default name command parameters and variables

Parameters and variables

Description

port <portlist> Specifies the port numbers to clear of names.

ATTENTION

If you omit this parameter, the system uses the port number you specified in the interface command.

Setting port speed

You can set the speed and duplex mode for a port. This section covers:

•"speed command" (page 237)

•"default speed command" (page 238)

•"duplex command" (page 239)

•"Enabling or disabling a port" (page 233)

speed command

The speed command sets the speed of the port. The syntax for the speed command is:

speed [port <portlist>] {101001000auto}

The speed command is executed in the Interface Configuration command mode.

Table 96 "speed command parameters and variables" (page 237) describes the parameters and variables for the speed command.

Table 96

speed command parameters and variables

Parameters and	Description
variables
port <portlist>	Specifies the port numbers to configure the speed.
	Enter the port numbers you want to configure.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks