Nortel Networks 2500 Series Configuring PoE port parameters using the CLI, Poe poe-trap command

160Power over Ethernet for the Ethernet Routing Switch 2526T-PWR and 2550T-PWR

Table 35 "poe poe-power-usage-threshold command parameters and variables" (page 160) describes the parameters and variables for the poe poe-power-usage-threshold command.

Table 35

poe poe-power-usage-threshold command parameters and variables

Parameters and

variables

Description

<1-99>

Enter the percentage of total available power you want the switch to use prior to sending a trap.

ATTENTION

The default setting is 80%.

Unit

Set a percentage usage threshold above which the system sends a trap for each unit.

poe poe-trap command

The poe poe-trapcommand enables the traps for the PoE functions on the Ethernet Routing Switch 2500-PWR. The syntax for the poe poe-trapcommand is:

poe poe-trap {Unit}

The poe poe-trapcommand is executed in the Global Configuration command mode.

no poe-trap command

The no poe-trapcommand disables the traps for the PoE functions on the Ethernet Routing Switch 2500-PWR. The syntax for the no poe-trapcommand is:

no poe-trap {Unit}

The no poe-trapcommand is executed in the Global Configuration command mode.

Configuring PoE port parameters using the CLI

You can configure power parameters for each port on the Ethernet Routing Switch 2500 PWR Series using the CLI. You enable the power and set the power limit and power priority on each port. This section covers the following topics:

•"no poe-shutdown command" (page 161)

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks