Nortel Networks 2500 Series manual Enable command, Configure command, Interface command

Basic navigation 91

logout

The logout command is in all command modes.

The logout command has no parameters or variables.

enable command

The enable command changes the command mode from User EXEC to Privileged Exec mode. The syntax for the enable command is:

enable

The enable command is executed in the User Exec command mode.

The enable command has no parameters or variables.

configure command

The configure command moves you to the Global Configuration (config) command mode and identifies the source for the configuration commands. The syntax for the configure command is:

configure {terminalnetwork}

The configure command is executed in the Privileged EXEC command mode.

Table 11 "configure command parameters and variables" (page

91)describes the parameters and variables for the configure command.

Table 11

configure command parameters and variables

Parameters and	Description
variables
terminal network	Specifies the source for the configuration commands for the
	Ethernet Routing Switch 2500 Series:
	terminal—a you to enter Global Configuration command
	mode to enter configuration commands network—lets you
	set up parameters for auto-loading a script at boot-up or for
	loading and executing a script immediately

interface command

The interface command moves you to the Interface Configuration (config-if) command mode. The syntax for the interface command is:

interface FastEthernet <portlist>

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks