Nortel Networks 2500 Series manual Lldp command, 32768

218System configuration using the CLI

•"no lldp config-notification command" (page 220)

•"default lldp config-notification command" (page 220)

•"lldp tx-tlv command" (page 221)

•"no lldp tx-tlv command" (page 221)

•"default lldp tx-tlv command" (page 222)

•"lldp status command" (page 222)

•"no lldp status command" (page 223)

•"default lldp status command" (page 223)

•"show lldp command" (page 224)

•"show lldp port command" (page 226)

lldp command

The lldp command sets the LLDP transmission parameters. The syntax for the lldp command is:

lldp [tx-interval <5-32768>] [tx-hold-multiplier <2-10>] [reinit-delay <1-10>] [tx-delay <1-8192>] [notification-interval <5-3600>]

The lldp command is executed in the Global Configuration command mode.

Table 76 "lldp command parameters and variables" (page 218) describes the parameters and variables for the lldp command.

Table 76

lldp command parameters and variables

Parameters and	Description
variables
tx-interval	Sets the interval between successive transmission cycles.
<5-32768>
tx-hold-multiplier	Sets the multiplier for tx-interval used to compute the Time
<2-10>	To Live value for the TTL TLV.
reinit-delay	Sets the delay for re-initialization attempt if the adminStatus
<1-10>	is disabled.
tx-delay <1-8192	Sets the minimum delay between successive LLDP frame
>	transmissions.
notification-interva	Sets the interval between successive transmissions of LLDP
l <5-3600>	notifications.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks