260Configuring the switch using Device Manager

The following table describes the System tab fields.

Table 117

System tab fields

Field

Description

 

 

sysDescr

The assigned system description.

 

 

sysUpTime

The time since the system was last booted.

 

 

sysObjectID

The unique sysObjectID (OID) assigned to the device.

 

 

sysContact

Type the contact information (in this case, an e-mail

 

address) for the system administrator.

 

 

sysName

Type the name of this device.

 

 

sysLocation

Type the physical location of this device.

 

 

SerNum

The switch serial number.

 

 

AuthenticationTraps

Click to enable or disable. When you enable, SNMP

 

traps are sent to trap receivers for all SNMP access

 

authentication. When you disable, no traps are received.

 

To view traps, click the Trap toolbar button.

 

 

ReBoot

By default, the switch is in the Running mode. The

 

reboot command initiates a hardware reset.

 

 

AutoPVID

Click to enable or disable. When you enable, AutoPVID

 

is activated. When you disable, AutoPVID is inactivated.

 

 

ManagementVlanId

The current management VLAN ID.

 

 

StackInsertionUnitNu

This field specifies the unit number to be assigned to the

mber

next unit that joins the stack, when in stack mode.

 

 

AutoUnitReplacement

Click to enable or disable the auto-unit-replacement

Enabled

feature.

 

 

NextBootMgmt

The transport protocol(s) to use after the next boot of

Protocol

the agent.

 

 

CurrentMgmtProtocol

The current transport protocol(s) that the agent supports.

 

 

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks

Page 260
Image 260
Nortel Networks 2500 Series manual Following table describes the System tab fields, System tab fields Field Description