Nortel Networks 2500 Series manual Default speed command parameters and variables

238Ethernet port management using the CLI

Parameters and	Description
variables

		ATTENTION
		If you omit this parameter, the system uses the port
		number you specified in the interface command.
101001000auto	Sets speed to:
	•	10—10 Mb/s
	•	100—100 Mb/s
	• 1000—1000 Mb/s or 1 GB/s
	•	auto—autonegotiation

ATTENTION

When you set the port speed for autonegotiation, ensure that the other side of the link is also set for autonegotiation.

default speed command

The default speed command sets the speed of the port to the factory default speed. The syntax for the default speed command is:

default speed [port <portlist>]

The default speed command is executed in the Interface Configuration command mode.

Table 97 "default speed command parameters and variables" (page

238)describes the parameters and variables for the default speed command.

Table 97

default speed command parameters and variables

Parameters and	Description
variables
port <portlist>	Specifies the port numbers to set the speed to factory
	default. Enter the port numbers you want to set.

ATTENTION

If you omit this parameter, the system uses the port number you specified in the interface command.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks