Nortel Networks 2500 Series Poe poe-priority command, Syntax for the poe poe-prioritycommand is

162Power over Ethernet for the Ethernet Routing Switch 2526T-PWR and 2550T-PWR

Table 37 "poe poe-shutdown command parameters and variables" (page

162)describes the parameters and variables for the poe poe-shutdown command.

Table 37

poe poe-shutdown command parameters and variables

Parameters and	Description
variables
port <portlist>	Enter the port numbers on which you want to disable
	power.
	The default value is enabled.

ATTENTION

If you omit this parameter, the system uses the port entered with the interface FastEthernet command.

poe poe-priority command

The poe poe-prioritycommand lets you set the power priority for each port to low, high, or critical. The system uses the port power priority settings to distribute power to the ports depending on the available power budget.

The syntax for the poe poe-prioritycommand is:

poe poe-priority [port <portlist>] {low high critical}

The poe poe-prioritycommand is executed in the Interface

Configuration command mode.

Table 38 "poe poe-priority command parameters and variables" (page

162)describes the parameters and variables for the poe poe-prioritycommand.

Table 38

poe poe-priority command parameters and variables

Parameters and	Description
variables
port <portlist>	Enter the port numbers on which you want to disable
	power.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks