Nortel Networks 2500 Series manual Port row of your choice, select from the lists, Click Submit

326Configuring the switch using web-based management

Item	Range	Description
Alias		Displays the name, or alias, you assigned the port. To
		assign or change the name, enter up to 26 alphanumeric
		characters.
Trunk		The trunk group that the switch port belongs to as specified
		in the Trunk Member fields on the MultiLink Trunk page.
Status	(1) Enabled	Choose to enable or disable the port. You can also use this
	(2) Disabled	field to control access to any switch port.
		The default setting is Enabled.
Link		The current link state of the corresponding port as follows:
		Up: The port is connected and operational
		Down: The port is not connected or is not operational.
Link Trap	(1) On	Choose to control whether link up/down traps are sent to
	(2) Off	the configured trap receiver from the switch.
		The default setting is On.
Autonegotiation	(1) Enabled	Choose to enable or disable the autonegotiation feature.
	(2) Disabled
		Choosing to enable autonegotiation sets the
		corresponding port speed to match the best service
		provided by the connected station, up to 100Mb/s in
		full-duplex mode.

			ATTENTION
			Autonegotiation also enables auto sensing on 10/100
			ports.
			The default setting is Enabled.
Speed / Duplex	(1) 10Mbs / Half		Lets you manually configure any port to support a specific
	(2)	10Mbs / Full	Ethernet speed and duplex setting.
	(3)	100Mbs / Half
	(4)	100Mbs / Full	The default setting is 10 Mbs/Half when autonegotiation is
	(5) 1000Mbs / Full
			disabled and 1000 Mb/s full-duplex for gigabit ports only.

2 In the port row of your choice, select from the lists.

3 Click Submit.

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks