Configuring PoE using web-based management 171

Item

Description

Current Status

Displays the status of the PoE feature. It displays:

 

 

 

 

 

 

Disabled—detecting function is disabled

 

 

 

Searching—detecting function is enabled and the system is searching for

 

 

 

a valid powered device on this port

 

 

 

Delivering power— detection found a valid powered device and the port

 

 

 

is delivering power

 

 

 

Fault—power-specific fault detected on the port

 

 

 

Test—detecting function is in test mode, which is set using SNMP

 

 

 

Other fault—detecting function is idle due to fault

 

 

 

 

 

 

 

ATTENTION

 

 

 

Nortel recommends against using the test operational status.

 

 

 

 

 

 

 

 

 

Classifica-

 

Classification is a way to tag different terminals on the power over LAN network

 

tion

 

according to their power consumption. Devices such as IP telephones, WLAN

 

 

 

access points, and others are classified according to their power requirements.

 

 

 

The meaning of the classification labels is defined in the IEEE 802.3af

 

 

 

specification.

 

 

 

This parameter is valid only while a device is being powered.

 

 

 

 

 

Limit (Watt)

 

Sets the maximum amount of power supplied to that port.

 

 

 

The range for Ethernet Routing Switch 2500 Series is 3W to 16W. The default

 

 

 

value is 16W.

 

 

 

 

 

Priority

 

Priority is used to determine which port(s) are shut down when the total power

 

 

 

 

 

 

of the Ethernet Routing Switch 2500 Series exceeds the power budget for

 

 

 

that switch (or available DTE power). The lower priority ports are shut down

 

 

 

in favor of higher priority ports.

 

 

 

The range is low, high, and critical. The default value is low.

 

 

 

 

 

 

 

ATTENTION

 

 

 

When two ports have the same priority and one must be shut down, the port

 

 

 

with the higher port number is shut down first.

 

 

 

 

 

 

 

 

 

Volt (V)

 

Displays the measured voltage supplied by the port.

 

 

 

 

 

Current (mA)

 

Displays the measured current supplied by the port.

 

 

 

 

 

Power (Watt)

 

Displays the measured power supplied by the port.

 

 

 

 

 

Nortel Ethernet Routing Switch 2500 Series

Overview — System Configuration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007

Copyright © 2007, Nortel Networks

Page 171
Image 171
Nortel Networks 2500 Series manual Description