Kathrein UFS 902 First Installation Single-cable system manual, Selection user-defined

FIRST INSTALLATION: Single-cable system (manual)

If one or more receivers are already present on the system and an additional receiver is to be connected, you must assign the new receiver a transmission frequency that is not already in use (otherwise the receivers will interfere with each other).

Depending on the system to which they are connected, a maximum of four or eight receivers may be connected to a single-cable system (a twin receiver counts as two receivers).

Connected equipment

Use the  buttons to select the type of system to which they are connected or the single-cable system components fitted (refer to the manuals, instructions and notes for the system and the system components). Available options:

-user-defined

-KATHREIN UAS 481 (single-cable feed system, max. four receivers)

-KATHREIN EXR 551 (single-cable switching matrix, max. four receivers applies also for EXR 501)

-KATHREIN EXR 552 (single-cable switching matrix, max. four receivers)

-KATHREIN EXU 908 (single-cable matrix, max. eight receivers)

-	EXR 4 subscriber	(for future Kathrein single-cable (switching) matrices, max. four receivers)
-	EXR 8 subscriber	(for future Kathrein single-cable (switching) matrices, max. eight receivers)

Selection “user-defined”

Transmission channel

Use the  buttons to select a free available transmission channel.

Transmission frequency

Use the number buttons to input the four-digit transmission frequency.

No frequency can be used by more than one receiver. The receivers would interfere with each other.

You can find the necessary information (transmission frequencies) in the documentation supplied with your system.

22