SEARCHING FOR CHANNELS (CHANNEL SEARCH)
Network Search
Use the buttons (On/Off) to select whether a network search should be performed. If you set the network search to “Off”, only the factory stored transponders of the satellites you previously selected will be searched for new as yet unlisted channels.
If you set the network search to “On”, the transponder network enables additional transponders that have not yet been stored to be located. They are then stored and searched for new channels in the same way as the existing transponders.
When you have made your settings, use the buttons to select “Start Search” and press
the button to start the search. You can cancel the search at any time by pressing the button. During the search you will see a display that shows you the progress of the search and the channels found so far. Newly found channels are identified with the designation “New” after the channel name.
After completion of the search, you will see the following message (example):
Press the button. You will be asked whether you wish to save the changes or not. Selection is performed using
the buttons and is confirmed using the button. If you select “Yes, save changes”, the newly found channels will be added to the end of the channel list. Then press the
button to exit the menu. The channel list is opened on to the TV screen by pressing the button (see also section
CHANNEL SEARCH WITH SERVICE ID
The buttons allow you to select different sets of parameters for the search.
Satellite
Use the buttons to select the satellite that is transmitting the channels to be searched. Make sure your reception system is aligned to the selected satellite.
60