CONNECTION AND SETUP
The following section is intended specifically for specialist dealers. You need not refer to this section unless you are carrying out the installation yourself.
The “Connection Examples” section provides a sample configuration.
Do not connect the receiver to the power supply until all installation work has been properly carried out. Refer to the information in the “Safety Instructions” section.
CONNECTING THE UNIT (SAT IF CONNECTIONS)
Connect the Sat IF input on the receiver to the satellite reception system. Use a coaxial cable with a standard F connector.
If the F standard connectors are not yet fitted on the cable, strip the insulation from the cable as shown in the following illustration and carefully twist the F standard connectors on to the ends of the cables until they are securely seated.
When fitting the connector, make sure that no wires from the braid are touching the inner conductor, so no short circuit can occur.
The quality of the reception signal depends on this connection!
RECEPTION REQUIREMENTS
Make sure that your satellite antenna system is equipped at least with a universal LNB for digital reception in the
RECEPTION SYSTEM PRESETS
The presets for the control signals have been made for standard reception systems, i.e. 14/18 V for polarity reversal and 22 kHz switching signal for low/high band changeover on
8