Code Search

RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 11

previously Learned functions for that mode are deleted. The mode is reset to its power-on default state.

The Code List Entry method is the quickest and easiest programming method. Code Lists are specified on pages 69-77 of this User’s Guide. To enter a code directly from one of the Code Lists, follow these steps:

1.Manually turn on the component to be controlled (TV, VCR, DVD, PVR/DVR, etc.).

2.Press and hold the SETUP key on the rubber keypad for

2-3 seconds until the LED indicator light remains on and the touchscreen shows the Code Setup Mode? Screen.

3.Release the SETUP key.

4.Press and release the desired component key (TV, VCR, SAT, etc.) on the LCD touchscreen. For AUX, press and release the LCD AUX key followed by the desired component key to be programmed under that key.

Note: The AUX key automatically defaults to Cable Mode unless another selection is made.

5.Enter the three-digit code for your component brand from the corresponding Code Lists at the back of this User’s Guide. If your brand has more than one code listed, begin with the first code. When a valid code from the list is entered, the LCD displays the Code Save Success Screen, followed by the Code Setup Mode? Screen. For an invalid code entry, the LCD displays the Invalid Entry Made Screen for two seconds before displaying the Code Setup Mode? Screen. In this case, no changes are made.

6.Before the code can be tested on the chosen component, return to normal operation by pressing the LCD EXIT key and then the LCD OK key on the Exit Setup Screen.

7.To test the code, turn the component on. Aim the RCU1010RF at the component and press and release the ON•OFF key. If you have entered the correct code number for your component, it responds to the ON•OFF key. If the component responds, no further programming is required.

8.If your component does not respond, try the next code in the list for your brand by repeating the procedure starting at step 2. If no other codes exist for your brand, try the Code Search or Code Autosearch methods.

If the component you wish to control does not respond to any of the codes you have entered using the Code List Entry, you can search the entire Code List for a code that will control your component. A particular component might not be listed in the Code List or might be listed under a different brand. Remember: The Code Search method may require up to 300 keypresses.

When you enter a valid code for any given mode (e.g., when you enter a code for a TV), the default key labels are displayed on the touchscreen and any previously Learned functions for that mode are deleted. The mode is reset to its power-on default state.

To search for a specific code in one of the Code Lists, follow these steps:

1.Manually turn on the component to be controlled (TV, VCR, DVD, PVR/DVR, etc.).

2.Press and hold the SETUP key on the rubber keypad for 2-3 seconds until the LED indicator light remains on and the touchscreen shows the Code Setup Mode? Screen.

3.Release the SETUP key.

	4. Press and release the SETUP key again. The LCD displays	11
	the Code Search Mode? Screen.	11
	the Code Search Mode? Screen.