InFocus 570, 560 manual Connecting the LCD end of the LitePro cable

Page 14

Setting Up the LitePro

If you are installing the projector on the ceiling, refer to the Ceiling Mount Installation Guide for recommendations. (The Ceiling Mount Kit is sold separately; refer to ”Accessories” on page 53 for order information.)

3.Remove the lens cover.

4.Plug the power cord into the LitePro, then plug it into your elec- trical outlet. (A surge-protected power strip is recommended if power surges are common in your area.)

5.Make sure your computer and monitor are turned off.

6.Locate the Y-shaped LitePro cable that was shipped with your projector. Connect the end labeled “LCD” to the “Computer” connector on the side of the projector as shown below. (The “Computer” connector is in the “SOURCE 1” area of the LitePro’s connector panel.)

Figure 3. Connecting the “LCD” end of the LitePro cable

7.Locate your computer’s monitor cable; it connects your monitor to your computer. Unplug it at the computer end, leaving the monitor end attached.

You will attach the LitePro cable to the monitor cable’s connector on the computer in the next step.

6

LitePro 560/570 User’s Guide

Image 14
Contents LCD Projector Users Guide Fold and tear here Page Page Certifications Declaration of Conformity Contents Power Cord Safety SummaryPower Source Do not look into the lensLamp GroundingFuse Hot SurfacesIntroduction Not shownCompatibility Cables and AdaptersIf You Need Assistance Remote Control Programmer KitUsage Guidelines Setting Up the LitePro Image Size measured diagonallyConnecting the LCD end of the LitePro cable Connecting an IBM-compatible desktop computer Connecting a Macintosh desktop computer Connecting an IBM-compatible laptop computer Connecting a Macintosh PowerBook Connecting a Composite Video Cable Connecting an S-Video Cable Connecting the Audio from a Video Player Connecting an external speaker Connecting a microphone Setting Up the LitePro Using the Remote Control Using the LiteProBasic Image Adjustment Turning the LitePro OffFocusing the Image Adjusting the HeightSwitching to the Spare Lamp Switching to the Spare LampUsing the Remote Control Buttons MenuNext Arrow buttonsSelect/enter Mute VolumePrev MicProg StandbyUsing the Menus MenuMaking Changes to Menu Functions Audio MenuHighlighting Menu Functions Removing the Menu from the Screen Resetting Menu Functions to the Default SettingsMenu 1 Functions BrightnessLeft/Right SyncUp/Down Source Prompt Menu 2 FunctionsRear Projection Auto Standby Test PatternRS-232 Reset NtscSource Enable PaletteProg Button Language TrackingText Mode and Pixel Slice Video TypeComp SharpnessVolume and Audio Lock Audio Menu FunctionsBalance and Fade BassTreble Loudness Maintenance Cleaning the LensReplacing the Projection Lamps Opening the Lamp Door Replacing Batteries in the Remote Control Bulb GuardInstalling New Batteries Replacing the FuseLocating the Fuse Removing the Fuse Holder Troubleshooting Before You Call for AssistanceProblem Color or VGA text not being projected Solutions to Common ProblemsProblem Nothing on screen Problem Image is too wide or narrow for screen Problem Image is not centered on the screenProblem Only the test pattern is displayed Problem Image is out of focusProblem Image is noisy or streaked Problem Image and menus are reversed left to rightProblem LitePro displays vertical lines, bleeding or spots Problem Projected colors don’t match the monitor’s colorsSpecifications AppendixAppendix Accessories Cable Connector Pin Assignments LCD ConnectorMonitor and VGA Connectors GNDLaptop Display Activation Chart ASTFN-F1 Appendix Index Assistance, see Technical Support audioLite show button 22 LitePro Quadra, see Macintosh Index Limited Warranty 010-0060-05 USA