1 You must install the projection bulbs the first time you use the LitePro.
Refer to the “Read Me First” card or page 40 of the User’s Guide for instructions.
2 Place the LitePro on a flat surface within six feet of your power source and your computer.
3 Remove the lens cover.
4 Plug in the LitePro’s power cord.
5 Make sure your computer and monitor are turned off.
6 Plug the “LCD” end of the LitePro cable into the “COMPUTER” con- nector on the side of the LitePro.
If your computer is a Macintosh, attach the Mac adapters before doing step 8. Attach one adapter to the “VGA” end of the LitePro cable. Attach the other adapter to the “MONITOR” end of the LitePro cable.
7 Locate your computer’s monitor cable. Unplug it at the computer end, leaving the monitor end attached.
8 Connect the LitePro cable to the monitor connector on your com- puter.
If you want to display your presen- tation on your computer’s monitor as well as on the projection screen, attach the “MONITOR” end of the LitePro cable to the end of the monitor’s cable.
9 LP570 only: If you want to connect your computer’s sound board, a video player, a speaker system, a microphone, or a second computer, refer to the instructions in User’s Guide.
10 If you attached your monitor in Step 8, turn on the monitor.
11 Press the “” side of the power switch to power up the LitePro. The test pattern will be projected onto the screen. If necessary, adjust the height of the LitePro and focus the lens.
12 Turn on your computer. The com- puter image will be projected onto the screen.
If your computer is... | You’ll need... |
|
|
|
|
R
no adapters | |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
Apple Macintosh or PowerBook | 2 Mac |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ||||
| adapters |
|
|
|
|
|
|
|
|
| |
|
|
| |||||||||
|
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
Macintosh PowerBook | 1 Mac adapter | ||||||||||
| and your | ||||||||||
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|