Maintenance
•Save the box. You may need it later to pack the lamps for shipping.
11.Close the lamp door.
Never operate the LitePro with the lamp door open or removed. This disrupts the air flow, causing it to overheat.
Bulb Guard
Your LitePro is equipped with a lamp life detection system called Bulb Guard. When the operating lamp is near the end of its life or has become degraded, Bulb Guard causes the lamp to blink. When this happens, switch to the spare lamp. After you have finished your presentation and the LitePro has cooled, replace the old lamp with a new one.
Replacing Batteries in the Remote Control
Follow these steps to replace the batteries.
1.Turn the remote face down in your hand.
2.Slide the battery cover off in the direction shown below.
Figure 20. Removing the Battery Cover
3.Remove the old batteries.
4.Install two new AAA alkaline batteries as shown in Figure 21.
5.Replace the battery cover.
42 | LitePro 560/570 User’s Guide |