Setting Up the LitePro
17.Turn on the projector by pressing the “” side of the power switch on the side of the projector.
•While the projector is on, you can switch the projection lamp off by pressing the standby button on the remote.
•After about 5 seconds, the projector test pattern appears. (If it does not, refer to ”Troubleshooting” on page 47. If you are using an
•If the image is not projected directly on the screen, adjust the height of the elevator. Refer to ”Adjusting the Height” on page 18 for instructions.
•If you need to focus the projector, turn the focus ring on the projector’s lens until the image is clear. Refer to ”Focusing the Image” on page 18 for more information.
With some computers, the order in which you power up the equipment is very important. We recommend that you always turn on the LitePro FIRST. This is especially important if your computer is a Macintosh.
18.Turn on your computer.
Your LitePro is now ready to use. See ”Using the LitePro” on page 17 for information about using the remote and the
16 | LitePro 560/570 User’s Guide |