Troubleshooting
Problem: Image and menus are reversed left to right
•Rear projection mode is probably set. To switch back to forward projection:
1.Press the menu button to display Menu 1.
2.Use the right or left arrow buttons to highlight “Menu 2”.
3.Press select/enter to display Menu 2.
4.Use the right or left arrow buttons to highlight “Rear Projec- tion”.
5.Press select/enter to enable Rear Projection. The image imme- diately changes to display the mirror image. (Press select/ enter again to change it back.)
6.Press menu again to remove the menu.
Problem: LitePro displays vertical lines, “bleeding” or spots
•Adjust the tracking. Refer to “Tracking” on page 33 for more information.
•The projection lens may need cleaning.
Problem: Image is “noisy” or streaked
•Adjust the sharpness. Refer to “Sharpness” on page 35 for more information.
•Adjust the sync. Refer to “Sync” on page 27 for more information.
Problem: Projected colors don’t match the monitor’s colors
•Adjust the brightness. Remember that, just as there are differences in the displays of different monitors, there are often differences between the computer image and the projected image. Refer to “Brightness” on page 26 for more information.
Problem: “EEPROM Failed” displays on the menu
•One of the integrated circuits inside the LitePro has failed. The only functionality that is lost is that the LitePro will reset the menu functions to their factory defaults when you turn it off. Call In Focus Technical Support; refer to “If You Need Assistance” on page 3.
50 | LitePro 560/570 User’s Guide |