InFocus 560, 570 manual Switching to the Spare Lamp

Page 27

Using the LitePro

Switching to the Spare Lamp

The LitePro was shipped with two projection lamps. To avoid breaking during shipping, they are not installed at the factory. You must install them before you can use the LitePro. Refer to the “Read Me First” document that was shipped with your LitePro for instructions. “Replacing the Projection Lamps” on page 40 also describes this procedure.

When both lamps are installed in the LitePro, only one is used at a time. The other is available as a spare for when the active lamp fails. The average lamp life is about 50 hours.

To switch to the spare lamp:

•Gently slide the lamp changer knob to the other side of the projector as shown here.

Figure 13. Switching to the Spare Lamp

When switching lamps, be careful not to touch the exhaust grill on the door. This area is very hot when the projector is operating.

LitePro 560/570 User’s Guide

19

Image 27

Contents LCD Projector Users Guide Fold and tear here Page Page Certifications Declaration of Conformity Contents Do not look into the lens Safety SummaryPower Source Power CordHot Surfaces GroundingFuse LampNot shown IntroductionCables and Adapters CompatibilityRemote Control Programmer Kit Usage GuidelinesIf You Need Assistance Image Size measured diagonally Setting Up the LiteProConnecting the LCD end of the LitePro cable Connecting an IBM-compatible desktop computer Connecting a Macintosh desktop computer Connecting an IBM-compatible laptop computer Connecting a Macintosh PowerBook Connecting a Composite Video Cable Connecting an S-Video Cable Connecting the Audio from a Video Player Connecting an external speaker Connecting a microphone Setting Up the LitePro Turning the LitePro Off Using the LiteProBasic Image Adjustment Using the Remote ControlAdjusting the Height Focusing the ImageSwitching to the Spare Lamp Switching to the Spare LampMenu Using the Remote Control ButtonsArrow buttons Select/enterNext Mic VolumePrev MuteStandby ProgMenu Using the MenusAudio Menu Highlighting Menu FunctionsMaking Changes to Menu Functions Brightness Resetting Menu Functions to the Default SettingsMenu 1 Functions Removing the Menu from the ScreenSync Up/DownLeft/Right Menu 2 Functions Rear ProjectionSource Prompt Test Pattern RS-232Auto Standby Ntsc ResetPalette Source EnableProg Button Tracking LanguageVideo Type Text Mode and Pixel SliceSharpness CompAudio Menu Functions Volume and Audio LockBass TrebleBalance and Fade Loudness Cleaning the Lens MaintenanceReplacing the Projection Lamps Opening the Lamp Door Bulb Guard Replacing Batteries in the Remote ControlReplacing the Fuse Installing New BatteriesLocating the Fuse Removing the Fuse Holder Before You Call for Assistance TroubleshootingSolutions to Common Problems Problem Nothing on screenProblem Color or VGA text not being projected Problem Image is out of focus Problem Image is not centered on the screenProblem Only the test pattern is displayed Problem Image is too wide or narrow for screenProblem Projected colors don’t match the monitor’s colors Problem Image and menus are reversed left to rightProblem LitePro displays vertical lines, bleeding or spots Problem Image is noisy or streakedAppendix SpecificationsAppendix Accessories LCD Connector Cable Connector Pin AssignmentsGND Monitor and VGA ConnectorsAST Laptop Display Activation ChartFN-F1 Appendix Assistance, see Technical Support audio IndexLite show button 22 LitePro Quadra, see Macintosh Index Limited Warranty 010-0060-05 USA