How to determine the position of the projector for a given screen size
1.Determine the aspect ratio of your screen, (16:9 or 4:3)? If you have a 16:9 screen, refer to "Installation for a 16:9 ratio screen" on page 15. If you have a 4:3 screen, refer to "Installation for a 4:3 ratio screen" on page 16.
2.Select your screen size.
3.Refer to the table and find the closest match to your screen size in the left columns labelled 'Screen Diagonal' Using this value, look across this row to the right to find the corresponding average distance from screen value in the column labelled 'Average'. This is the projection distance.
4.On that same row, look across to the right column and make note of the vertical Offset value. This will determine the final vertical offset placement of the projector in relation to the edge of the screen.
5.The recommended position for the projector is aligned perpendicular to the horizontal centre of the screen, at the distance from the screen determined in step 2 above, and offset by the value determined in step 3
above.
For example, if you are using a 120 inch screen with 16:9 aspect ratio, the average projection distance is 4829 mm and with a vertical offset of 244 mm.
If you place the projector in a different position (to that recommended), you will have to tilt it down or up to center the image on the screen. In these situations, some image distortion will occur. Use the Keystone function to correct the distortion. See "Correcting keystone" on page 25 for keystone correction.
How to determine the recommended screen size for a given distance
This method can be used for situations where you have purchased this projector and would like to know what screen size will fit in your room.
The maximum screen size is limited by the physical space available in your room.
1.Determine the aspect ratio of your screen, (16:9 or 4:3)? If you have a 16:9 screen, refer to "Installation for a 16:9 ratio screen" on page 15. If you have a 4:3 screen, refer to "Installation for a 4:3 ratio screen" on page 16.
2.Measure the distance between the projector and where you want to position the screen. This is the projection distance.
3.Refer to the table and find the closest match to your measurement in the average distance from screen column labelled 'Average'. Check that your measured distance is between the min and max distances listed on either side of the average distance value.
4.Using this value, look across that row to the left to find the corresponding screen diagonal listed in that row. That is the projected image size of the projector at that projection distance.
5.On that same row, look across to the right column and make note of the vertical Offset value. This will
determine the final placement of the screen in relation to the horizontal plane of the projector.
For example, if you have a 4:3 aspect screen and your measured projection distance was 4.8m (4800mm), the closest match in the Average column is 4851mm. Looking across this row shows that a 2500mm (2.5m) screen is required. If you can only obtain imperial sized screens, the listed screen sizes on either side of the 2.5m screen are the 8' and 9' screens.
Checking the min. and max. projection distance values for these screen sizes, indicates that the 4.8m measured projection distance will fit the 2.5m and 8' screens. The projector can be adjusted (using the zoom control) to display on these different screen sizes at that projection distance. Be aware that these different screens have different vertical offset values.