BenQ W100 user manual Menu system

Page 31

Menu system

Please note that the on-screen display (OSD) menus vary according to the signal type selected.

Functions available when receiving different signal types...

Sub-Menu					PC / DVI-A	DVI-D	Video / S-Video	Component Video

							Application Mode
					Application Mode		Keystone
					Keystone		Color Temp
					Keystone		Color Temp
					Color Temp		Brightness
Picture					Brightness		Contrast
					Contrast		Color
							Tint*

					Aspect Ratio
					H Position	IRE	IRE
					H Position		IRE
					V Position		Aspect Ratio
					V Position	Aspect Ratio	Aspect Ratio
Pro-Picture					Phase	Aspect Ratio	Sharpness
Pro-Picture					Phase		Sharpness
					H. Size

					Mute
					Volume
					Volume
					OSD Time
Setting					OSD Time
Setting					Quick Cooling
					Reset

					Mirror
					Source Scan
					Language
					Language
					Splash Screen
Advance					High Altitude Mode
					Auto Off
					Economic Mode

					Source		Source	Source
					Source		System	Resolution
					Resolution		System	Resolution
					Resolution		Application Mode	Application Mode
					Application Mode		Application Mode	Application Mode
Information					Application Mode		Equivalent Lamp	Equivalent Lamp
					Equivalent Lamp Hour		Hour	Hour
							Hour	Hour

*When a Video or S-Video signal is connected, the function is only available with NTSC system selected.

Operation 31

Image 31

Contents Page Table of contents Safety instructions Safety, regulatory and legal informationDo not place inflammables near the projector Safety Instructions Regulatory and legal information Introduction Projector featuresShipping contents Lower side Projector exterior viewFront / upper side Rear sideProjector Controls and functionsRemote control operation Remote controlReturns all settings to the factory preset values Choosing a location Positioning your projectorObtaining a preferred projected image size Safety instructions for ceiling mounting of the projectorAspect image in a 169 aspect display area Positioning your projector Installation for a 169 ratio screen Installation for a 43 ratio screen Better video quality Connecting Video source devicesConnection Best video qualityConnecting Audio Projector Connecting a DVI source deviceWith a DVI DVI-I or DVI-D cable With a VGA to DVI-A cable ComputerTo connect the projector to a Component Video source device Connecting a Component Video source deviceTo connect the projector to an S-Video source device Connecting an S-Video source deviceTo connect the projector to an composite Video source device Connecting a composite Video source deviceOperation Switching input signalStart up Fine-tuning the image size and clarity Adjusting the projected imageAdjusting the projection angle Auto-adjusting the imageFor example Correcting keystonePersonalizing the projector menu display Operating in a high altitude environmentSelecting the aspect ratio Optimizing the imageDVI-D/ YPbPr/ S-Video/ Video Signal Input Selecting an application modeOther adjustments PC/ DVI-A Signal InputSelecting a color temperature Adjusting contrastAdjusting color Adjusting tintMenu operation Using the menusDisconnect the power cord from the wall socket Shutting down the projectorMenu system Picture menu Pro-Picture menu Setting menu Advance menu Information menu Care of the projector MaintenanceCalculation of lamp hour Lamp informationReplacing the lamp Restart the projector Pull the lamp from the projectorIndicators Temperature informationIllustration Please contact your dealer for assistance Projector needs 90 seconds to cool down. OrPlug the power cord into the AC inlet on TroubleshootingAdjust the focus of the lens using the focus ring Projector specifications SpecificationsDimensions Supported timing for Video and S-Video inputs Timing chartHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for PC inputLimited warranty WarrantyFor other information, please visit support.BenQ.com Disclaimer Copyright