BenQ W100 user manual Introduction, Projector features

Page 7

Introduction

Projector features

The projector integrates high-performance optical engine projection and a user-friendly design bringing you an enjoyable home viewing experience.

•Compact and portable unit

•High quality manual zoom lens

•Ability to display 16.7 million colors

•Multi-language on-screen menus

•10 sets of preset application mode

•7-segment color wheel

•25dB Noise Level in Economic Mode

•Native 16:9 aspect ratio

•2 sets of Component Video sockets allowing a second Component Video device to remain connected and standing by so that it can be readily selected without swapping cables

•A DVI connector with HDCP function making digital viewing quality possible

• The apparent brightness of the projected image will vary depending on the ambient lighting conditions, selected input source contrast/brightness settings, and is directly proportional to projection distance.

•The lamp brightness will decline over time and may vary within the lamp manufacturers specifications. This is normal and expected behavior.

Introduction 7

Image 7

Contents Page Table of contents Safety instructions Safety, regulatory and legal informationDo not place inflammables near the projector Safety Instructions Regulatory and legal information Introduction Projector featuresShipping contents Lower side Projector exterior viewFront / upper side Rear sideProjector Controls and functionsRemote control operation Remote controlReturns all settings to the factory preset values Choosing a location Positioning your projectorObtaining a preferred projected image size Safety instructions for ceiling mounting of the projectorAspect image in a 169 aspect display area Positioning your projector Installation for a 169 ratio screen Installation for a 43 ratio screen Better video quality Connecting Video source devicesConnection Best video qualityConnecting Audio Projector Connecting a DVI source deviceWith a DVI DVI-I or DVI-D cable With a VGA to DVI-A cable ComputerTo connect the projector to a Component Video source device Connecting a Component Video source deviceTo connect the projector to an S-Video source device Connecting an S-Video source deviceTo connect the projector to an composite Video source device Connecting a composite Video source deviceOperation Switching input signalStart up Fine-tuning the image size and clarity Adjusting the projected imageAdjusting the projection angle Auto-adjusting the imageFor example Correcting keystonePersonalizing the projector menu display Operating in a high altitude environmentSelecting the aspect ratio Optimizing the imageDVI-D/ YPbPr/ S-Video/ Video Signal Input Selecting an application modeOther adjustments PC/ DVI-A Signal InputSelecting a color temperature Adjusting contrastAdjusting color Adjusting tintMenu operation Using the menusDisconnect the power cord from the wall socket Shutting down the projectorMenu system Picture menu Pro-Picture menu Setting menu Advance menu Information menu Care of the projector MaintenanceCalculation of lamp hour Lamp informationReplacing the lamp Restart the projector Pull the lamp from the projectorIndicators Temperature informationIllustration Please contact your dealer for assistance Projector needs 90 seconds to cool down. OrPlug the power cord into the AC inlet on TroubleshootingAdjust the focus of the lens using the focus ring Projector specifications SpecificationsDimensions Supported timing for Video and S-Video inputs Timing chartHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for PC inputLimited warranty WarrantyFor other information, please visit support.BenQ.com Disclaimer Copyright