Shipping contents
The projector is shipped with the cables required for connection to a PC and to video equipment. Carefully unpack and verify that you have all of the items shown below. If any of these items are missing, please contact your place of purchase.
Standard accessories
The supplied accessories will be suitable for your region, and may differ from those illustrated.
PUSH 
C
W100
|
| User’s | Quick start | User’s manual | Remote control |
Projector | Soft carry case | manual | guide | CD | with batteries |
|
|
|
|
|
|
Cleaning cloth Audio cable | Component Video cable | Power cord | Video cable | ||
|
|
|
|
| |
Optional accessories |
|
|
|
| |
1. | Spare lamp kit | 3. | DVI cable |
| |
2. | Ceiling mount kit | 4. | Component Video to VGA | ||
Remote control batteries
1. To open the battery cover, turn the remote control over to view its back, push on the finger grip on the cover and slide it down in the direction of the arrow as illustrated. The cover will slide off.
2.Remove any existing batteries (if necessary) and install two new AAA batteries observing the battery
polarities as indicated in the base of the battery compartment. Positive (+) goes to positive and
3.Refit the cover by aligning it with the case and sliding it back up into position. Stop when it clicks into place.
Notes on handling batteries
•Do not mix old batteries with new ones, or mix different types of batteries.
•Avoid leaving the remote control and batteries in an excessive heat or humid environment like the kitchen, bathroom, sauna, sunroom, or in a closed car.
•Dispose of used batteries according to the battery manufacturer’s instructions and local environment regulations for your region.
•If the remote control will not be used for an extended period of time, remove the batteries to avoid damage to the control from possible battery leakage.
8 Introduction