BenQ W100 user manual Copyright, Disclaimer

Page 47

Notices

Copyright

Copyright 2006 by BenQ Corporation. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of BenQ Corporation.

Disclaimer

BenQ Corporation makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Further, BenQ Corporation reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes.

*DLP, Digital Micromirror Device and DMD are trademarks of Texas Instruments. Others are copyrights of their respective companies or organizations.

Notices 47

Image 47
Contents Page Table of contents Safety instructions Safety, regulatory and legal informationDo not place inflammables near the projector Safety Instructions Regulatory and legal information Introduction Projector featuresShipping contents Lower side Projector exterior viewFront / upper side Rear sideProjector Controls and functionsReturns all settings to the factory preset values Remote controlRemote control operation Choosing a location Positioning your projectorAspect image in a 169 aspect display area Safety instructions for ceiling mounting of the projectorObtaining a preferred projected image size Positioning your projector Installation for a 169 ratio screen Installation for a 43 ratio screen Better video quality Connecting Video source devicesConnection Best video qualityConnecting Audio Projector Connecting a DVI source deviceWith a DVI DVI-I or DVI-D cable With a VGA to DVI-A cable ComputerTo connect the projector to a Component Video source device Connecting a Component Video source deviceTo connect the projector to an S-Video source device Connecting an S-Video source deviceTo connect the projector to an composite Video source device Connecting a composite Video source deviceStart up Switching input signalOperation Fine-tuning the image size and clarity Adjusting the projected imageAdjusting the projection angle Auto-adjusting the imageFor example Correcting keystonePersonalizing the projector menu display Operating in a high altitude environmentSelecting the aspect ratio Optimizing the imageDVI-D/ YPbPr/ S-Video/ Video Signal Input Selecting an application modeOther adjustments PC/ DVI-A Signal InputSelecting a color temperature Adjusting contrastAdjusting color Adjusting tintMenu operation Using the menusDisconnect the power cord from the wall socket Shutting down the projectorMenu system Picture menu Pro-Picture menu Setting menu Advance menu Information menu Care of the projector MaintenanceCalculation of lamp hour Lamp informationReplacing the lamp Restart the projector Pull the lamp from the projectorIllustration Temperature informationIndicators Please contact your dealer for assistance Projector needs 90 seconds to cool down. OrAdjust the focus of the lens using the focus ring TroubleshootingPlug the power cord into the AC inlet on Dimensions SpecificationsProjector specifications Supported timing for Video and S-Video inputs Timing chartHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for PC inputFor other information, please visit support.BenQ.com WarrantyLimited warranty Disclaimer Copyright