BenQ W100 Warranty, Limited warranty, For other information, please visit support.BenQ.com

Page 46

Warranty

Limited warranty

BenQ warrants this product against any defects in material and workmanship, under normal usage and storage.

Proof of purchase date will be required with any warranty claim. In the event this product is found to be defective within the warranty period, BenQ’s only obligation and your exclusive remedy shall be replacement of any defective parts (labor included). To obtain warranty service, immediately notify the dealer from which you purchased the product of any defects.

Important: The above warranty shall be void if the customer fails to operate the product in accordance with BenQ’s written instructions, especially the ambient humidity must be in-between 10% and 90%, temperature in- between 0°C and 40°C, altitude lower than 10000 feet, and avoiding to operate the projector in a dusty environment. This warranty gives you specific legal rights, and you may have other rights which vary from country to country.

For other information, please visit support.BenQ.com.

46 Warranty

Image 46
Contents Page Table of contents Safety, regulatory and legal information Safety instructionsDo not place inflammables near the projector Safety Instructions Regulatory and legal information Projector features IntroductionShipping contents Rear side Projector exterior viewFront / upper side Lower sideControls and functions ProjectorRemote control operation Remote controlReturns all settings to the factory preset values Positioning your projector Choosing a locationObtaining a preferred projected image size Safety instructions for ceiling mounting of the projectorAspect image in a 169 aspect display area Positioning your projector Installation for a 169 ratio screen Installation for a 43 ratio screen Best video quality Connecting Video source devicesConnection Better video qualityConnecting Audio Computer Connecting a DVI source deviceWith a DVI DVI-I or DVI-D cable With a VGA to DVI-A cable ProjectorConnecting a Component Video source device To connect the projector to a Component Video source deviceConnecting an S-Video source device To connect the projector to an S-Video source deviceConnecting a composite Video source device To connect the projector to an composite Video source deviceOperation Switching input signalStart up Auto-adjusting the image Adjusting the projected imageAdjusting the projection angle Fine-tuning the image size and clarityCorrecting keystone For exampleOperating in a high altitude environment Personalizing the projector menu displayOptimizing the image Selecting the aspect ratioPC/ DVI-A Signal Input Selecting an application modeOther adjustments DVI-D/ YPbPr/ S-Video/ Video Signal InputAdjusting tint Adjusting contrastAdjusting color Selecting a color temperatureShutting down the projector Using the menusDisconnect the power cord from the wall socket Menu operationMenu system Picture menu Pro-Picture menu Setting menu Advance menu Information menu Maintenance Care of the projectorLamp information Calculation of lamp hourReplacing the lamp Pull the lamp from the projector Restart the projectorIndicators Temperature informationIllustration Projector needs 90 seconds to cool down. Or Please contact your dealer for assistancePlug the power cord into the AC inlet on TroubleshootingAdjust the focus of the lens using the focus ring Projector specifications SpecificationsDimensions Supported timing for PC input Timing chartHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for Video and S-Video inputsLimited warranty WarrantyFor other information, please visit support.BenQ.com Copyright Disclaimer