BenQ W100 user manual Connecting Audio

Page 18

Connecting Audio

The projector has a built-in mono speaker which is designed to provide basic audio functionality. Any stereo audio input (if provided), is mixed into a common mono audio output through the projector speaker.

If you have a separate sound system, you will most likely want to connect the audio output of your Video source device to that sound system, instead of to the mono audio projector.

The audio connections illustrated in the following sections are provided for informational purposes only. You need not connect audio to the projector if there is an alternate sound system available, or if audio is not required.

18 Connection

Image 18

Contents Page Table of contents Safety, regulatory and legal information Safety instructionsDo not place inflammables near the projector Safety Instructions Regulatory and legal information Projector features IntroductionShipping contents Rear side Projector exterior viewFront / upper side Lower sideControls and functions ProjectorRemote control Remote control operationReturns all settings to the factory preset values Positioning your projector Choosing a locationSafety instructions for ceiling mounting of the projector Obtaining a preferred projected image sizeAspect image in a 169 aspect display area Positioning your projector Installation for a 169 ratio screen Installation for a 43 ratio screen Best video quality Connecting Video source devicesConnection Better video qualityConnecting Audio Computer Connecting a DVI source deviceWith a DVI DVI-I or DVI-D cable With a VGA to DVI-A cable ProjectorConnecting a Component Video source device To connect the projector to a Component Video source deviceConnecting an S-Video source device To connect the projector to an S-Video source deviceConnecting a composite Video source device To connect the projector to an composite Video source deviceSwitching input signal OperationStart up Auto-adjusting the image Adjusting the projected imageAdjusting the projection angle Fine-tuning the image size and clarityCorrecting keystone For exampleOperating in a high altitude environment Personalizing the projector menu displayOptimizing the image Selecting the aspect ratioPC/ DVI-A Signal Input Selecting an application modeOther adjustments DVI-D/ YPbPr/ S-Video/ Video Signal InputAdjusting tint Adjusting contrastAdjusting color Selecting a color temperatureShutting down the projector Using the menusDisconnect the power cord from the wall socket Menu operationMenu system Picture menu Pro-Picture menu Setting menu Advance menu Information menu Maintenance Care of the projectorLamp information Calculation of lamp hourReplacing the lamp Pull the lamp from the projector Restart the projectorTemperature information IndicatorsIllustration Projector needs 90 seconds to cool down. Or Please contact your dealer for assistanceTroubleshooting Plug the power cord into the AC inlet onAdjust the focus of the lens using the focus ring Specifications Projector specificationsDimensions Supported timing for PC input Timing chartHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for Video and S-Video inputsWarranty Limited warrantyFor other information, please visit support.BenQ.com Copyright Disclaimer