Motorola QIP7000 installation manual ONT1000M Connections, Key Name Description

Installation

B

			Table 6 – ONT1000M Connections
Key	Name	Description
1	Telco ground	Connects the ONT1000M and the subscriber’s telephone, data, and
	terminal	cable TV wiring networks to protective ground at the electrical service
		ground electrode.
2	Fiber in	OptiFit connector provides input to the ONT1000M from the PON
		network.
3	UPS input	Connects the ONT1000M to an external Uninterruptible Power Supply
	terminal strip	(UPS), as follows:
		•	POS — connects to the +12 VDC output terminal on the external
			power supply (UPS).
		•	NEG — connects to the –RTN output terminal on the external power
			supply (UPS).
		•	Signal RTN — connects to the SIG RTN output terminal on the
			external power supply (UPS).
		•	ON BATT — ONT1000M is operating off of the battery. Connects to
			the ON BATT terminal on the UPS.
		•	REPLACE BATT — battery present but not operational. Connects to
			the BATT MISSING terminal on the UPS.
		•	LOW BATT — battery low, needs changing. Connects to the LOW
			BATT terminal on the UPS.
		•	Using a UPS is optional for a network-powered ONT1000M.
4	Telephone	Termination point for subscriber’s telephone lines. These are insulation
	terminal strip	displacement type connectors (IDCs) and serve as input for four
		separate lines.
5	Ethernet	RJ-45 Ethernet high-speed data connection to the subscriber’s
	connection	computer.
6	Cable out	Cable TV output for distribution of video services to the customer
		premises.

QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual		20
574702-001 a	This document is uncontrolled pending incorporation in a Motorola CMS