Motorola QIP7000 installation manual Out-Of-Band Status fields are

Diagnostics

The Out-Of-Band Status fields are:

B

Field	Description
OOB Frequency	Indicates the OOB tuner center frequency, from 70 to 130 MHz.
Carrier Lock	Indicates whether the OOB receiver is locked to the carrier:
	OSD	Front Panel	Description
	YES	L	Carrier locked
	NO	U	Carrier unlocked
Data	Indicates whether data is being carried by the OOB and EMM traffic, which is
	tracked separately:
	OSD	Front Panel	Description
	YES	On	OOB data detected within last 5 seconds
	NO	Off	OOB data not detected within last 5 seconds
EMM Data	Indicates whether EMM data is being carried on the OOB stream:
	OSD	Front Panel	Description
	YES	On	EMM data detected within last 5 seconds
	NO	Off	EMM data not detected within last 5 seconds
SNR	When carrier lock has been established, displays an estimate of the carrier
	signal-to-noise ratio in dB, with an explanation:

•GOOD — Good value

•FAIR — Marginal signal level, check the signal

•POOR — Unusable signal

•INVALID — Invalid SNR value

AGC	When carrier lock has been established, displays an estimate of the AGC as a
	percentage, with an explanation:
	•	GOOD — Good value
	•	FAIR — Marginal signal level, check the signal
	•	POOR — Unusable signal
	•	INVALID — Invalid AGC value
EMM Provider ID	Displays the conditional access stream for the QIP7000 series, in hexadecimal.
EMM PID	Displays the packet identifier (PID) stream the QIP7000 series tunes to for EMM
	data, in hexadecimal.
Network PID	Displays the network PID to which the QIP7000 series is tuned to receive
	network messages, in hexadecimal.
Hunt Mode	The hunt mode includes Hunted, None, Round Robin (RR), Search (SRCH), Fixed
	Frequency (FIX), or EMM Provider ID (EMM).
LKC	The last known carrier is the last valid OOB frequency displayed in MHz and
	ranges from 70 to 130 MHz, with the specific values of: 75.25, 104.20, 72.75,
	92.25, 98.25, 107.25, 107.40, 110.25, 116.25, and 103.75.
	LKC will remain blank during hunting if a valid carrier has not been found, and will
	be populated once a valid OOB is found.
Man Pag	Only displayed when QIP7000 series is not hunting and the operator presses
	“menu” button. The operator can then scroll up or down to one of the specific
	OOB frequencies.

QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual		41
574702-001 a	This document is uncontrolled pending incorporation in a Motorola CMS