Motorola QIP7000 Verifying the MoCA Network, Operational Check for the Remote Control

Installation

B

Verifying the MoCA Network

To verify that the nodes are connected, check the rates on the Connected Home Status diagnostic (see Troubleshooting).

Operational Check for the Remote Control

The operational check tests communication with the remote control:

Feature	Testing Procedure
Power on	Press POWER on the remote control to turn on the QIP7000 series.
	Tune to the output channel (3 or 4) if using the RF output.
Channel selection	Scan through the channels using the CHANNEL + or - keys.
	Tune to several channels by entering the channel number using the
	numeric keys.
Volume control	Press VOLUME + or - on the remote control to increase the volume to its
	upper limit, lowest level, and to a comfortable level.
	Press MUTE to turn the sound off. Press MUTE again to restore the sound.

If the QIP7000 series does not operate properly, refer to the Troubleshooting section.

Optimizing the High-Definition Settings

This subsection describes how to optimize SD and HD video settings and closed captioning based on subscriber preferences.

Before you optimize the output settings:

1.Connect the QIP7000 series set-top to other home entertainment devices.

2.Plug the QIP7000 series set-top into a power outlet.

3.Initialize the QIP7000 series set-top and authorize services.

4.Turn the TV on.

Note: For an HDMI connection, be sure the TV is on and connected to the HDMI connector before adjusting the settings. Motorola recommends using HDMI cables less than 20 meters long.

To optimize the output settings:

1.Power off the QIP7000 series and then immediately press the MENU key on the front panel twice. If the TV is on, the on-screen menu lists the settings you can configure:

QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual		30
574702-001 a	This document is uncontrolled pending incorporation in a Motorola CMS