Divar XFHardware setup en 23
4 | Hardware setup |
| This chapter contains detailed information about the hardware installation and connection of |
| external equipment to the unit. The connector types and their pin signals are described. Most |
| of the connectors are located at the rear panel of the unit. For convenience, one USB port is |
| located on the front of the unit to connect a mouse or memory device. |
| All the input/output ports are Safety Extra Low Voltage (SELV) circuits. SELV circuits should |
| only be connected to other SELV circuits. |
4.1 | Desktop installation |
| Place the unit on a stable, flat surface. Install the two supplied silver side covers by: |
1. inserting them on each side,
2. sliding them towards the front of the unit.
| Figure 4.1 Side cover installation |
4.2 | Rack mounting |
| The unit can be mounted in a |
| includes two rack mounting brackets. |
Mounting
1.Remove the four cross head screws (two on each side) located near the front panel on the right and left side of the unit.
2.Secure the supplied brackets to each side using the same four cross head screws (two on each side) that were just removed.
3.To install several units directly on top of each other, remove the rubber feet from under the unit by prying them loose with a small screwdriver.
4.Install the unit into the rack using the hardware supplied with the rack and following the rack manufacturer’s instructions.
Figure 4.2 Securing the rack mounting bracket
Bosch Security Systems | Installation manual | F.01U.135.429 2.5 2009.08 |