38 en Operating instructionsDivar XF
5.3 | Viewing pictures |
|
| ||
| The unit has two monitor outputs, A and B. The way in which these monitors display pictures | ||||
| depends on how the system is configured. When an alarm or motion input is detected, the | ||||
| camera picture with the Alarm/Motion indicator can be displayed on monitor A, B, or both. | ||||
| When multiple alarms or motion occur, camera pictures are combined in a multiscreen | ||||
| window on monitor A, B, or both. |
| |||
5.3.1 | Monitor A |
|
| ||
| Monitor A is the main monitor. It shows | ||||
| pictures of both analog and IP cameras. Status messages, alarms, motion, and video loss | ||||
| warnings are also displayed on this monitor. When the menu system is activated it is | ||||
| displayed on this monitor. |
| |||
5.3.2 | Monitor B |
|
| ||
| Monitor B displays | ||||
| Selecting a monitor to control |
| |||
| To control the display on monitor A: |
| |||
| 1. | Check that the | light on the front panel is lit. | ||
| 2. | If | is not lit, press the monitor | key. |
To control the display on monitor B:
1.Check that the light on the front panel is lit.
2.If is not lit, press the monitor key
5.3.3Viewing
The drawing shows all possible views for monitor A and B. Some multiscreen views may have been disabled during set up. The Divar model and the number of connected cameras also influence the available multiscreen views.
Single
1
Quad
12
34
4x4
1 | 2 | 3 | 4 |
|
|
|
|
5 | 6 | 7 | 8 |
|
|
|
|
9 | 10 | 11 | 12 |
|
|
|
|
13 | 14 | 15 | 16 |
|
|
|
|
3x3
1 | 2 | 3 |
|
|
|
4 | 5 | 6 |
|
|
|
7 | 8 | 9 |
|
|
|
Figure 5.3 Divar XF supports single, quad, 3x3, and 4x4 screen viewing
The multiscreen modes can have different multiscreens that can be shown in sequence to display all camera pictures.
F.01U.135.429 2.5 2009.08 | Installation manual | Bosch Security Systems |