Viking Access Systems f1 gate Operator Positioning, Technical Tips Operator and Arm Geometry

Page 18

GATE OPERATOR INSTALLATION

Operator Positioning

!IMPORTANT: Swing Gates must not open into public access areas.

The gate must be installed in a location so that enough clearance is supplied between the gate, while opening and closing, and adjacent structures to reduce the risk of entrapment.

!TECHNICAL TIPS: Operator and Arm Geometry

•Increasing “C” dimension provides better gate control and stability by reducing the effects of inertia and deceasing the gate leverage against the operator.

•Following to the geometrical formulas and relationships provided is recommended.

Arm Assembly: VA-F1ARM20 and VA-F1SWL20

VA-F1ARM (Standard) Typical installations. Gate travels level.

VA-F1SWL20 (Option) Gate travels on an incline, up to 10° and with a maximum pull scale force of 70 lbs. to manually pull the gate up grade,

1 6	VIKING TECHNICAL SUPPORT 1.800.908.0884

Image 18

Contents Instructions Viking F-1 Swing Gate Operator Vehicular Gate Operator Revision F1NXMN10.D October Parts Diagram DescriptionOperator References Limit Setup Buttons Control Board ReferencesTable of Contents Important Safety Information Important Safety InstructionsImportant Installation Instructions Important Installation Instructions Maintenance General Safety PrecautionsInstall the gate operator only when UL325 Gate Operator ClassificationsGlossary Photo Beam non-contact sensor Installation Secondary Entrapment ProtectionManual Release Edge Sensor contact sensor InstallationWhen manual operation is required To resume normal operationAudible Alarm Reset Switch Installation Manual Reset for the Audible Alarm Alternative Power 24VAC / VDC 60VA or Solar Specifications Single Phase 50Hz / 60Hz Locate Control ButtonsGate Operator Installation Concrete Pad OptionPost Mounting Option Required ADD-ON PART# VA-F1PSOperator Positioning Technical Tips Operator and Arm GeometryStep Electrical Installation Tips for proper ground installationHigh Voltage Supply Option Low Voltage Supply Option Solar Supply OptionLimits Setup At the Limit Cam & Holder assembly1a 1b Limits Setup MASTER/SLAVE Setup Two Wire CommunicationCable Requirements Wireless Communication Options Required ADD-ON Choose option a or BODS Initial SettingsTimer Hold Open Timer Obstruction Detection SensorLast Open Power Failure Option Control Board SetupAuto Open Power Failure Option Fail Safe ModeODS Obstruction Detection Sensor When the Obstruction Sensor detects an obstruction it willObstruction Sensor Primary Entrapment Protection Flashing OverloadViking Heater Viking Lock ModeUse the LCD Display to activate this feature To set the heater to turn on at the Close LimitThis page Left Blank Intentionally COM + Accessory ConnectionsRe-Open Photo Beam vehicular Safety Check for proper operationRadio Receiver Typical Open-Stop-CloseOpen Only Guard Station Anti-Tailgate, Open Commands & Guard StationOpen Commands ATG Anti-TailgateViking Loop Rack Accessory Connections Guidelines for Loop InstallationPower for the Locks Magnetic Lock, Lock SolenoidMagnetic Lock Lock Solenoid Synchronization with B-12 Barrier Arm B-12 Synchronization OptionTroubleshooting LED ReferencesTroubleshooting LCD MSG Meaning LCD Display ReferencesTroubleshooting Error Messages Solutions CheckAccess Control Connections Power ConnectionsGeneral Appendix aRelays In General Technical TIP Viking usesCommon Radio Receivers Connections Panels Appendix CSolar Applications Batteries & FuseViking Konnect Diagnostic Tool On-site remote Viking Expansion ProductsViking Konnect Master/Slave Kit Secure and reliable OUR Continuous Commitment to Excellence Standard Features